7-in-1 Replacement Brush Heads Set for DSENFURN Electric Spin Scrubber

The 7-in-1 Replacement Brush Heads Set of Electric spin scrubber is worth buying if you own the DSENFURN scrubber and wore out the stiff round brush. The hard-bristle heads pulled algae off my siding in a couple of minutes with barely any pressure. Buy it if you clean outside surfaces.

How this review was made: written from my own video review of this product. Every opinion here is my own, from using it myself.

The Algae Was Winning Until I Snapped On the Wide Head

Before this I was on my knees scrubbing siding panels one at a time with a hand brush, slow, ugly work. I snapped on the wide hard-bristle head, hit mode 3, and dipped it in a bucket of soapy water. That’s the whole setup: no prep, no priming, just press and go.

Within seconds you could see it. The moisture and the brush together were lifting it, and the bristles themselves went visibly dirty. I wasn’t leaning on it. A little pressure, not very much.

Swapping Brush Heads Takes About a Second

Each head snaps in by hand, no tool, no twist-lock to fight. Mid-job I grabbed the small hard-bristled one so I could get along the edge of the siding where the big brush rides over the lip. Same deal, press, click, back to work.

After use they need a rinse, because they hold the grime they pull off. The bristles on these are 1.8 times thicker than a typical brush, which is the whole reason you’d buy a replacement set rather than a cheap generic pack. The ongoing cost of ownership here is basically soap and the odd charge over USB-C.

Three Modes, and It Tells You Which One You’re On

Press power, it says “power ready,” then M cycles low, medium and high. You can hear it call out the mode every time you switch, which is useful when you’re outside with gloves on and not looking at the LCD. The screen itself is really sharp looking.

I stayed on 3 the whole time for the siding. The motor is obviously powerful enough to handle hard to remove algae, and that’s the one thing I wanted to know going in.

Check the current price on Amazon →

These Brush Heads Aren’t Just a Bathroom Thing

Seven heads sounds like padding until you realize each one is sized and stiffened for a different surface: the soft head for finished hardwood and countertops, the hard round head for concrete and algae-covered siding, the sponge for tile grout, the sharp tip for faucet crevices. Using the wrong head doesn’t just slow you down, a stiff bristle on a finished floor will scratch it.

The sharp head is built for corners, gaps, faucets and crevices. The sponge head is for countertops and bathroom tile. I bought this for the siding and it delivered there, but the soft head is next up on my hardwood floors, where I’d rather not find out the hard way that I grabbed the wrong bristle stiffness.

What Bugged Me

The big wide head can’t do edges. That’s the one real friction I hit. On the lip of each siding panel the large brush just skates past, so I had to stop and swap to the small hard-bristle head to get into the tighter areas. Not a dealbreaker, the swap is quick, but if you’re doing a whole wall you’re changing heads constantly rather than running one brush end to end.

The other thing is it needs water. I had a bucket of soapy water going, and the results came from the moisture and the brush working together. Dry scrubbing isn’t the move here.

Thicker Bristles Are the Whole Point of a Replacement Set

Brush heads are the part that wears out, not the motor. Bristles splay, go soft, and suddenly the machine feels weak when it’s the head that died. These are listed as the same original brushes that ship in the scrubber box, with bristle 1.8 times thicker than other brushes, which matters most on abrasive surfaces like siding and concrete where a thin bristle folds over fast.

Mine held shape through the siding job with no visible flattening. One note on buying: this set sits around #125,894 in Health & Household with more than 50 picked up in the past month, so it’s a steady seller rather than a hot one. The price bounces a fair bit and has dropped well below its normal level before, so check the live price rather than assuming today is typical.

Who Should Grab These

Homeowners with exterior surfaces to clean get the most out of this. If you’ve got siding, concrete, brick, or a car and wheels, the hard-bristle heads plus rods out to 55 inches save you the panel-by-panel hand scrubbing I used to do. Renters with one small bathroom probably don’t need 7 brush heads.

And obviously you need the matching DSENFURN scrubber. These are replacement heads, not a machine.

Frequently Asked Questions

Will these brush heads fit a Philips Sonicare or another brand of scrubber?

No. The listing is specific that these fit the DSENFURN Electric Spin Scrubber shown in the main listing image. Brush heads for Philips Sonicare are a totally different mount and size, so don’t cross-shop them.

Can I use these on a car or wheels?

Wheels, yes, that’s listed as an intended use for the set. For paint I’d stick to the soft head and plenty of soapy water, since the hard bristles are the ones built for algae and concrete.

How do I clean the heads after a messy outdoor job?

Pop the head off and rinse it out under a tap or hose before the grime dries in the bristles. Mine were loaded with algae after a few minutes on the siding. Let them dry fully before they go back in the case.

Does the scrubber need an app or account?

No app, no account, no subscription. It’s a power button, an M button for the three modes, and USB-C charging. The voice prompt tells you what mode you’re on.

Get it now

7-in-1 Replacement Brush Heads Set of Electric

Get the best price on Amazon →

Affiliate link. See the disclosure at the top of this post.

🛍️ Shop everything in this video

Every product mentioned, in one place. These are affiliate links, so I may earn a small commission at no extra cost to you.

🛍️ Dsenfurn Upgraded Electric Spin Scrubber 8 in 1: check price on Amazon →